Hi Nidhi
IC the situation.
Analytics and the reporting is different. Consist of different data source.
Analytics is based on the Cube 0SM_BPMRH..
(Analytics Monitor write the information to this cube)
Reporting is based on the Cube 0SM_BPM. (If you set transfer BW option flag to your BPMon Monitor, then BPMon result is transfer to this cube).
I guess you have used analytics so I describe the possible check points on Analytics below.
For Analytics, used cube is 0SM_BPMRH. So if you cannot see the relevant data for last 5 days in this cube, I suspect 2 possibilities.
1)Data collection of your key figure in managed system failed due to some reason
=> If you configure data collection in background mode, I recommend you to check
whether BPM_DATA_COLLECTION_* job is running or not.
=>If you configure online mode, I recommend short dump at ST22 in managed system.
close to the defined data collection time.
Timeout issue or some other issue... If the issue comes from timeout, I recommend to
switch on background data collection mode.
2)Data collection in managed system was ok, but extraction to analytics cube was failed
=>I recommend you to check extractor log.
SolMan Admin workcenter => Infrastructure=>framewok=>extractor framework
=>check "BPMon Transactional Data Extractor"
Whether this exractor raise any error or not.
Also please check whether there is some change in managed system side.
For example, ST-A/PI upgrade.
Since above analysis requires certain knowlege, I recommend open SAP customer message.
Then expert can analyze by checking the system.
Best Regards
Keiji